Specifications
Electrical Requirements | 120V~ / 60Hz / 10A |
|
|
Motor No Load Speed | 2,750 RPM |
|
|
Belt Speed | 1,640 FPM |
Belt Size | 4” W x 24” L |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to al- low free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to pre- vent movement while working.
4.There must not be hazardous ob- jects, such as utility lines or foreign objects, nearby that will present a hazard while working.
SKU 97593 | For technical questions, please call | Page 9 |