ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
BELT SANDER TABLE
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Locate the M8x1.25x30mm hex head screw (A) Fig. 2, M8.4 flat washer (B), and table locking handle assembly (C), (D), (E) and (F). NOTE: The table locking assembly (C, D, E, and F) is shipped assembled. For ease in assembling table to sander, remove screw (F), spring (E), and handle (D) from locking stud (C).
3.Place table (G) Fig. 3, on sander by inserting belt (H) and platen (I) through opening (J) in table, as shown.
4.Insert M8x1.25x30mm hex head screw (A) Fig. 4, into hole in sander frame and through slot (K) underneath table and fasten using M8.4 flat washer and stud (C), tighten the stud (C) hand tight.
5.The M8.4 flat washer (B) and stud (C) are also shown in Fig. 5. Place handle (D) on end of stud and fasten in place using spring (E) and screw (F) Fig. 5.
6.The table (A) is shown completely assembled to the sander in Fig. 6. NOTE: The locking handle (B) is spring loaded and can be repositioned by pulling out the handle and repositioning it on the serrations located underneath
the handle.
WARNING: To avoid trapping the workpiece or your fingers between the table (A) and the sanding belt (D), adjust the table so that there is a maximum 1/16" between the work table and the belt (see the section “BELT TABLE ADJUSTMENTS”).
G
F D C B A
E
Fig. 2
IH
JG
Fig. 3
K
C
A
Fig. 4
C D F E
A
D
B
C
B
Fig. 5 | Fig. 6 |
6