Abrasive to Sanding Disc

Fig. 7

1.DISCONNECT MACHINE FROM POWER SOURCE.

2.Remove one-half of the abrasive backing (A) Fig. 7, to expose the adhesive.

3.Attach the lower section of the abrasive to the sanding disc (B), making sure that the abrasive edges fit the sanding disc edges exactly.

4.Remove the other half of the abrasive backing.

5.Attach the upper edge of the abrasive backing to the sanding disc. Press the entire abrasive to be certain that it is attached solidly to the sanding disc.

SANDING DISC GUARD AND TABLE

1.DISCONNECT MACHINE FROM POWER SOURCE.

2.Position the sanding disc guard with table (A) Fig. 8, over sanding disc (B).

3.Fasten the sanding disc guard with table (A) Fig. 9, to base using the two 10-24x3/8" pan head screws, and 3/16" flat washers, one of which is shown at (B).

WARNING: To avoid trapping the workpiece or your fingers between the table (A) and the sanding disc (B), adjust the table so that there is a maximum 1/16" between the work table and the disc (see the section “DISC TABLE ADJUSTMENTS”).

FASTENING SANDER TO SUPPORTING SURFACE

IMPORTANT: If the machine has a tendency to tip over or to walk on the supporting surface, the machine must be secured. Use the four holes, three of which are shown at (A) fig. 11 to attach the machine to the supporting surface.

Fig. 8

Fig. 9

Fig. 10

Fig. 11