off the Belt Sander.
(See Figures A and B.)
To Attach The Dust Bag:
DUST BAG (69)
Figure C
To attach the Dust Bag (69), simply clip the opening of the Dust Bag onto the Dust Port located on the Left Housing (18). (See Figure C.)
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
release the Trigger once.
(See Figure B.)
3.WARNING! Prior to using the Belt Sander (each time), make sure the Switch Lock mechanism is working properly. Release the Switch Lock mechanism before disconnecting the Belt Sander from its electrical outlet. Failure to do so will cause the tool to start immediately the next time it is plugged into an electrical outlet, resulting in possible injury or property damage.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Trigger of the tool off and unplug the tool from its electrical outlet before adjusting tool or installing accessories.
1.To start the Belt Sander, depress the Trigger (66). To stop the tool, release pressure on the Trigger. (See Figure B.)
2.To lock the Trigger (66) in the “ON” position for continuous operation, depress the Trigger and push in on the Switch Lock. The tool will continue to run. To turn off the tool, squeeze and
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
5.Make sure the workpiece is free from nails and any other foreign objects which could damage the Sanding Belt (46).
General Operating Instructions
1.Make sure the Trigger is released, then plug the Power Cord (14) into the nearest 120 volt, grounded, electrical outlet.
SKU 90045 | For technical questions, please call | Page 10 |