
Figure 4-6 Torque Wrench Operation
A
6”
TORQUE WRENCH CHART
When using a torque wrench in conjunction with a Bush Hog shaft or sheave wrench, the following chart must be used to achieve the correct torque of 200 ft./lbs.
Torque Wrench | 12” | 14” | 16” | 18” | 20” | 22” |
|
Length (A) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Torque Indicator | 133 | 140 | 145 | 150 | 154 | 157 |
|
Must Show | ft./lbs. | ft./lbs. | ft./lbs. | ft./lbs. | ft./lbs. | ft./lbs. |
|
|
|
|
|
|
|
|
|
4-7 TROUBLESHOOTING
Troubleshooting procedures are listed in Table
| Table |
|
|
|
| PROBLEM | PROBABLE CAUSE | REMEDY | |
|
|
|
|
|
| Uneven Cut | Cutter not level side to side | See SECTION III. | |
|
| or front to rear. |
|
|
|
| Belt slipping. | Adjust belt per paragraph | |
|
| Worn or bent blade(s). | Replace blade(s). | |
|
|
|
|
|
| Streaking or Windrowing | Possible | Clean cutter. | |
|
| material under cutter. |
|
|
|
| Cutter not level. | See SECTION III. | |
|
| Worn blades. | Replace blades. | |
|
| Belt slipping. | Adjust belt per paragraph | |
|
|
|
| |
| Noisy Cutter | Loose components. | Check all bolts for tightness. | |
|
| Low oil in gearbox. | Check oil per paragraph | |
|
|
|
| |
| Rapid Blade Wear | Blade contacting | Adjust cutting height to | |
| (cutting edge) | ground. | eliminate ground contact. | |
|
|
|
| |
| Rapid Blade | Cutter not being | Set tractor throttle for | |
| Wear | operated at rated PTO speed. | proper PTO speed. | |
|
|
| Use lower gear. | |
|
|
|
| |
| Cutter Vibrating | Cutter not being operated | Set tractor throttle for | |
|
| at rated PTO speed. | proper PTO speed. | |
|
| Blade(s) bent. | Replace blades. | |
|
| Foreign object wrapped | Remove object. | |
|
| around spindle or blade. |
|
|
16