INSTALLING THE RUBBER PAD
Improper installation of the rubber pad can cause damage to the rubber pad and the work surface.
The Polisher / Sander is sold with 1 Foam Pad And 1 Wool
Polishing Bonnet and includes a wrench for installation.
Check to be sure the Polisher / Sander is unplugged.
Install the rubber pad by turning the Polisher / Sander |
|
|
so the spindle faces up. Press the spindle locking button located on |
|
|
the top of the Polisher / Sander (Figure 2). Place the rubber pad on |
|
|
the spindle with the depressed section facing down (Figure 3). | Figure 2 | Figure 3 |
Next, place the clamp washer on the spindle and tighten with the | ||
wrench. (Figures 4 and 5). When installing the Foam pad, follow |
|
|
Figure 6 & 7, to apply to hook and loop fastener. |
|
|
Figure 4 | Figure 5 |
Figure 6 | Figure 7 |
INSTALLING THE POLISHING BONNET
Improper installation of the polishing bonnet can cause damage to the polishing bonnet and the work surface.
Make sure the Polisher / Sander is unplugged before installing the
Polishing Bonnet.
For best results, place the Polisher / Sander on a flat, sturdy |
|
| |
surface. Make sure the string on the bonnet is loose and unknotted |
|
| |
before proceeding. (Figure 8) Slip the bonnet evenly around the |
|
| |
rubber pad, and then tie the strings tightly. Secure the loose ends |
|
| |
by tucking them under the edge of the bonnet before using the | Figure 8 | Figure 9 | |
Polisher / Sander (Figure 9) | |||
|
|
PS07401 | 10 |