Remington Power Tools 494 operating instructions Operation

Page 14

Operation

1.Grasp muzzle and slide barrel forward rapidly until it stops. This sets piston into firing position and opens the chamber.

482-70

482-71

2.Insert power fastener into muzzle of tool, head end first. Push the fastener until point is even with end of tool. ALWAYS load the fastener first, then the power load.

		NOTE:
		Failure to start with
		the lowest power
		level can result in
		overdrive condition
482-71	482-72	and will result in
		damage to tool

(see page 13).

3.Select the proper Remington Power Load and insert into the chamber until it stops (see Application Chart on page 23).

4.Push barrel into housing to the closed position.

101437

14

Image 14

Contents Remington Index Before Using Safety Precautions Handling the ToolLoad Know Your Fastening Base Material Never make fastenings in spalled or cracked areas Operating Safety Never use power loads in firearms Plastic Flute WHY a Power Fastener Holds in Steel Why a Power Fastener HoldsWHY a Power Fastener Holds Concrete Fastening Into Concrete Power LoadsOverdriven Power Fasteners Piston Fastening Into SteelOperation Water Maintenance Troubleshooting GuideParts Centrals Baltimore ElectricParts List Model KEY Part DescriptionDisassembly AccessoriesTool Disassembly and Assembly Assembly Hole Stop Pin Breech Spring Receiver Barrel AssemblyTo Replace Buffer and Piston Buffer and Piston ReplacementTo Reassemble Application Chart For fastening this To thisLoad Color Code Stock Limited Warranty Agreement