Parkside PHP 500 A1 manual Introduction / Safety notes, Technical details, Workplace safety

Page 6

Technical details

Nominal voltage:

230 V~ 50 Hz

Nominal power:

approx. 40 W (500 W)

Heating up time:

approx. 4 min.

Protection class:

II /

Safety notes

ATTENTION! Please read all the instructions and advice. Failure to observe the instructions and advice given below may result in electric shock, fire and / or serious injury.

Keep all the safety advice and instructions in a safe place for future reference!

1. Workplace safety

a)Keep your working area clean and clutter-free. Untidy or poorly lit working areas can lead to accidents.

b)Do not allow the device to become wet. Do not operate it in a moist environment.

c)Keep children and other

people away while you are operating the electrical tool.

Distractions can cause you to lose control of the device.

Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device.

ATTENTION! This tool must be placed down on its wire stand 6 when it is not being used.

Introduction / Safety notes

2. Electrical safety

a)The mains plug on the device must match the mains socket. The plug must not be modified in any way. Do not use an adapter plug with devices fitted with a protective earth. Unmodified plugs and matching sockets reduce the risk of electric shock.

b)Avoid touching earthed surfaces such as pipes, radiators, ovens and refrig- erators with any part of your body.

There is an increased risk of electric shock if your body is earthed.

c)Keep the device away from rain or moisture. Water entering an electrical device in creases the risk of electric shock.

d)Do not use the mains lead for any purpose for which it was

not intended, e.g. to carry

the device, to hang up the device or to pull the mains plug out of the mains socket. Keep the lead away from heat, oil and sharp edges. Do not touch the mains lead if it becomes damaged or severed while you are working, instead pull the mains plug out of the mains socket immediately. Damaged or tangled mains leads increase the risk of electric shock.

e)When working outdoors with an elec- trical power tool always use extension cables that are also approved for use outdoors. The use of an extension cable suit- able for outdoor use reduces the risk of electric shock.

3. Personal safety

a)Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury.

GB/IE 7

Image 6
Contents HOT Glue GUN PHP 500 A1 GB / IE Page Table of contents Hot glue gun PHP 500 A1 Introduction FeaturesIntroduction Proper useElectrical safety Introduction / Safety notesWorkplace safety Personal safetyBefore first use Safety notes / OperationCareful handling and use of electrical power tools Preparing the tool for useService Operation / Maintenance and Cleaning / Service / WarrantyMaintenance and Cleaning WarrantyDisposal Kompernass Gmbh