Parkside PHP 500 A1 manual Operation / Maintenance and Cleaning / Service / Warranty

Page 8

Operation / Maintenance and Cleaning / Service / Warranty

Gluing:

Press the feed clamp 5 to regulate the flow of glue as required for your work.

1.Apply the glue in individual dots. Apply in zig- zags on flexible materials such as fabrics.

2.Immediately after applying the glue, press the two materials together for about 30 seconds. The glued joint can be loaded after about 5 minutes.

3.When you take a break from work, set the glue gun down on the wire stand 6 or in the charger 4 .

4.Remove any glue residue with a sharp knife after cooling. Glued joints can be loosened again by applying heat.

Switching off the device:

Pull the mains lead out of the mains socket.

Changing the nozzle:

Wear protective gloves.

Heat up the device for about 4 minutes. Change the nozzle 8 when it is hot.

DANGER OF BURNS! Touch the nozzle 8 only by the heat shield 9 . The nozzle tip is hot!

Maintenance and Cleaning

The glue gun is maintenance-free.

WARNING! Pull the mains lead out of the mains socket before you clean the tool. Always keep the device clean and dry.

Do not allow any liquids to enter the tool. Use a soft cloth to clean the housing. Never use petrol, solvents or cleaning agents that might attack plastic.

Service

WARNING! Have your device repaired only by qualified specialist personnel using original manufacturer

parts only. This will ensure that your device remains safe to use.

WARNING! If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. This will ensure that your device remains safe to use.

Warranty

The warranty for this appliance is for 3 years from the date of purchase. The ap- pliance has been manufactured with care and meticulously examined before deliv- ery. Please retain your receipt as proof of purchase. In the event of a warranty claim, please make contact by telephone with our Service Department. Only in this way can a post-free despatch for your goods be assured.

The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile compo- nents, e.g. buttons or batteries. This product is for private use only and is not intended for commercial use.

The warranty is void in the case of abusive and im- proper handling, use of force and internal tamper- ing not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty.

The warranty period will not be extended by repairs made unter warranty. This applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment.

GB

DES UK LTD

Tel.: 0871 5000 700 (£ 0.10 / minute)

e-mail: support.uk@kompernass.com

GB/IE 9

Image 8
Contents HOT Glue GUN PHP 500 A1 GB / IE Page Table of contents Features IntroductionHot glue gun PHP 500 A1 Introduction Proper useIntroduction / Safety notes Workplace safetyElectrical safety Personal safetySafety notes / Operation Careful handling and use of electrical power toolsBefore first use Preparing the tool for useOperation / Maintenance and Cleaning / Service / Warranty Maintenance and CleaningService WarrantyDisposal Kompernass Gmbh