12.control panel
12.1POWER ON (red) LED – The red POWER ON LED lights up when the charger is plugged in and receiving AC power.
12.2CHARGING STATUS (yellow and green) LED – The CHARGING STA- TUS LED glows yellow when the charger is charging and green when the battery is charged and in maintain mode.
LED Color/Flash Pattern Explanation
Red On | AC Power Present |
Yellow On | Charging |
Green On | Charge Complete |
13.operating instructions
WARNING: Failure to follow instructions may cause damage or an explo- sion. Read the entire instruction manual before use.
13.1Make sure that the charger is unplugged from the AC outlet.
13.2Connect one of the three optional output cables to the charger output con- nector.
13.3Connect the other end of the output cable to the battery.
13.4Plug the charger into the AC outlet. The POWER ON (red) LED will glow to show that AC power is present. Then the green and yellow LED will blink once as a
13.5After three seconds, the CHARGING (yellow) LED will glow to show that charging has begun. If none of the LEDs glow, or if the CHARGING (yel- low) LED does not glow, refer to the troubleshooting section. Charge time may vary from less than one hour to 12 hours.
13.6When charging is complete, the CHARGED (green) LED will glow and the charger will automatically go into maintain mode. The charger is now ready to be unplugged from the AC outlet.
NOTE: If the battery has not reached at least
• 8 •