Schumacher SE-520MA, SE-1275A important safety instructions Important Safety Instructions

Page 1

 

 

 

 

 

 

 

Battery

SE-520MA

2/10 Amp

12 Volt

 

 

Charger

SE-5212A

2/10/50 Amp

12 Volt

 

Owner's Manual

Models:

SE-1275A

2/12/75 Amp

12 Volt

 

 

 

 

 

 

 

 

 

 

 

 

–Save–

Important Safety Instructions

Read Rules for Safe Operation and Instructions Carefully

Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance that each time before using your charger, you read this manual and follow the instructions exactly.

WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

A.

IMPORTANT SAFETY INSTRUCTIONS

 

 

1.SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions for battery charger Models: SE-520MA,SE-5212A and SE-1275A.

A BATTERY CHARGER RECEIVES AC POWER FROM THE ELECTRIC OUTLET AND DELIVERS DC CUR- RENT TO THE BATTERY.

2.Before using battery charger, read all instructions and cautionary markings on (1 ) battery charger, (2) battery and (3) product using battery.

3.CAUTION - To reduce risk of injury, charge only lead acid type rechargeable batteries: Other types of batter- ies may burst causing personal injury and damage.

4.Do not expose to rain or snow.

5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons.

6.To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.

7.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

8.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:

(a) That pins on plug of extension cord are the same number, size and shape as those of plug on charger;

(b)That extension cord is properly wired and in good electrical condition;and

(c)That wire size is large enough for AC ampere rating of charger as specified below:

AC INPUT RATING, AMPERES

AWG SIZE OF CORD

Equal to or

but less than

Length of Cord, Feet

Greater than

 

25

50

100

150

 

 

 

 

 

 

0

2

18

18

18

16

2

3

18

18

18

14

6

8

18

16

12

10

 

 

 

 

 

 

9.Do not operate charger with damaged cord or plug - replace it immediately.

10.Do not operate charger if it has received a sharp blow, been dropped or otherwise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

12.To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.

SCHUMACHER ELECTRIC CORPORATION

801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179

Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280

Call Customer Service if you have questions: 1-800-621-5485

00-00-000579/0103

1

Image 1
Contents AC Input RATING, Amperes AWG Size of Cord Important Safety InstructionsBusiness Center Drive Mount PROSPECT, Illinois Preparing to Charge Personal PrecautionsCharger Location Operation Model SE-1275-A Battery Charger ControlsOperation -- Model SE-5212-A Follow These Steps When Battery is Installed in Vehicle DC Connection PrecautionsReading METER/LECTURA DEL Medidor Bateria a Plena CargaAC Power Cord Connection Instructions Follow These Steps When Battery is Outside VehicleCharge Rate Switch Operation InstructionsCharge Period Limited WarrantyStorage Problem Possible Cause Solution TroubleshootingAdvertencia Riesgos CON Gases Explosivos Instrucciones Importantes DE SeguridadPrecauciones Personales Preparativos Para CargarOperaciones Para EL Modelo SE-5212-A Posicion DEL CargadorOperacion Para EL Modelo SE-520-MA Cargue Automatico 10/12 AmperiosLectura DEL Medidor Arranque DEL MotorPrecauciones Para Conección DE Corriente Directa DC Instrucciones DE OperacionGarantia AlmacenamientoProblema Posible Explicacion Solucion Solucion DE Problemas