Schumacher MKC-10P important safety instructions Troubleshooting, Problem Possible Solution

Page 5

TROUBLESHOOTING

The battery charger is designed to work automatically. However, If a problem does occur, check the following:

PROBLEM

POSSIBLE

SOLUTION

 

 

 

No meter reading.

Charger is not plugged in.

Plug in

 

Connections are reversed.

With charger unplugged, reverse clamps and

 

 

reconnect (rock back and forth to bite in).

 

Poor electrical connection.

Clean clamps and battery poles and

 

 

reconnect (rock back and forth to bite in).

 

AC outlet is dead.

Plug in a lamp or other appliance to check for

 

 

voltage.

 

Battery is defective (will not accept

Have battery checked.

 

charge).

 

 

 

 

Charger will not turn on when

Battery recently used in vehicle and is

Battery does not need changing.

properly connected to power.

fully charged.

(If battery is in vehicle, turning on headlights

 

 

will lower battery voltage in a few seconds and

 

 

charger should then turn on.)

 

 

Battery has less than .7 volts, set to Manual

 

 

and retry.

 

 

 

Charger will not turn OFF.

Battery has a problem and will not

Have battery checked.

 

take a full charge.

(If in MANUAL, switch to AUTOMATIC).

 

 

 

Meter needle pulses (fluctuates)

Two or more batteries connected in

Requires more time to charge: continue

every few seconds AFTER THREE

parallel.

charging.

HOURS without slowing down.

 

 

 

Battery of 200 ampere hours or larger.

Requires more time to charge: continue

 

 

charging.

 

Battery is connected to application that

Requires more time to charge: continue

 

draws a small current (such as a

charging.

 

vehicle's dome light).

 

 

 

 

Charging current is less than full

Battery is partially charged.

Continue charging.

output rating of charger.

 

 

 

Battery is defective (battery plates are

Have checked and replace battery.

 

crusted) and will not accept a full

charge.

 

AC power supply is low.

Plug charger into another grounded AC outlet.

 

 

 

Meter needle moves to extreme

Severely discharged battery (but

Allow charging to continue until battery has

right, remains a short time, then

otherwise good battery).

recovered sufficiently to take a charge (Circuit

returns to zero, accompanied by a

 

breaker will continue to cycle and needle will

clicking sound.

 

swing side to side until battery has recovered).

 

In MANUAL with battery connections

Unplug charger and change to correct

 

reversed.

connections.

 

Battery is defective (will not accept

Have battery checked.

 

charge)

 

 

Charger is cycling after circuit breaking

Wait until charger automatically resets itself

 

overload.

(DO NOT RETURN FOR SERVICE).

 

 

 

NOTE:

This product is manufactured for Minn Kota by Schumacher Electric Corporation. If you have any questions regarding the operation of this charger please contact Schumacher Electric technical service at 1-800-621-5485, Ext. 322.

5

Image 5
Contents General Battery Safety Battery ChargerModel MKC-10P AMP 12 VoltsBattery SIZE/RATING Personal Precautions and SafetyPreparing to Charge Marine / or MCA AMP HR Deep CycleAmps Charged Charging Charge Complete Battery Charger ControlsReading Meters Operating Instructions Charging Battery OUT of the Vehicle Battery TypesTroubleshooting Circuit BreakerProblem Possible Solution TroubleshootingLimited Warranty MAINTENANCE/CLEANING InstructionsPage Important Safety Instructions