DISASSEMBLY AND ASSEMBLY OF TOOLS
Disconnect air supply from tool or shut off air supply and exhaust (drain) line of compressed air BEFORE performing maintenance or service to tool.
Before starting to disassemble or assemble this tool (any part or completely), be sure to read “Inspection,Maintenance and lnstal- lation” section.
To minimize the possibility of parts damage and for convenience, the steps for disassembly or assembly listed on the following pages are recommended.
The basic sections and instructions for removing them from the tool are as follows:
MOTOR SECTION
Remove collet nut (41751) and collet insert
5/32” hex type wrench, insert hex wrench thru collet body and into hex end of rotor to hold rotor from turning and remove collet body (41752).
Locating on flats of head, secure head in a suitable holding de- vice. Using a strap type wrench on motor housing, unthread and remove motor housing from head. Remove motor assembly from housing. For complete disassembly of motor, see page 7.
HEAD SECTION
Throttle components can be serviced without removing head sec- tion from tool. See page 8 for complete disassembly.
To remove screen (44933) from housing, remove retainer ring (35619) and exhaust sleeve
TYPICAL CROSS SECTION OF TOOL
6