Ingersoll-Rand SS5N5, SS3 owner manual These INSTRUCTIONS. Retain for Reference, Definitions

Page 1

ingersoll

IMPORTANT INFORMATION! READ AND FOLLOW

ll_*-]r-1=1ul li"

DEFINITIONS

/k_WILL cause DEATH, SEVERE INJURY or substantial property damage

WARNING CAN cause DEATH, SEVERE INJURY or substantiaI property damage,

CAUTION WILL or CAN cause MINOR INJURY or property damage.

GENERAL

SAFETY

PRECAUTIONS

,_ _

iNTAKE

AIR, Can contain carbon monoxide or other

contaminants. Will cause serious injury or death ingersoll-Rand air compressors are not designed, intended or approved for breathing air Compressed air should not be used for breathing air applications unless treated in accordance with all applicable codes and regulaUons,,

WARNING HAZARDOUS VOLTAGE Can cause serious injury or death. Disconnect power and bteed pressure from tank before servicing Lockout/Tagout machine. Compressor must be connected to properly grounded circuit See grounding instructions in manuat, Do not operate compressor tn wet conditions,, Store indoors

MOVING PARTS, Can cause serious injury Do not operate with guards removed. Machine may start automatically Disconnect power before servicing_ Lockout/Tagout machine,,

HOT SURFACES, Can cause serious injury, r DO not touch Allow to cool before servicing Do not touch hot compressor or tubing

HIGH PRESSURE AIR. Bypassing_ modifying or removing safety/relief valves can cause serious injury or death, Do not bypass, modify or remove safety/relief valves Do not direct air stream at body. Rusted tanks can cause explosion and severe injury or death Drain tank daily or after each use. Drain valve located at bottom of tank.

z_ CAUTION RISK OF BURSTING. Use only suitable air handling parts acceptable for pressure of not less than the maximum allowable working pressure of the machine.

Owner's Manual

Installation, Operation and Maintenance Instructions for Models SS3 and SS5

Stationary Air Compressors

THESE INSTRUCTIONS. RETAIN FOR REFERENCE.

Your air compressor unitis suitable for operating air too_s, caulking guns, grease guns, sandblasters, etc Depending on your application, the following accessories may be required:

@An air pressure regulator to adjust the alr pressure enlering the toot or accessory

An air line fitter for removal of moisiure and oil vapor in compressed air

An in-linelubricator to prolong lhe life of air tools.

ql, Separate air transformers which combine the !'unctions of air regulation andlor moisture and dirt removal

Cenlact your nearest authorized dealer or cal! 1-800-AIR-SERV for more information on air toots and accesser}as for your application

Ensure adequate lifting equipment is available for unloading and moving your unit to the inslaIlatton site

NOTE: Lifting equipment must be property rated for the weight of the unit.

Lift the unit by the shipping skid only,,Use straps to prevent tipping

Lk CAUTION

Do not work on or walk under the compressor

while

 

it is suspended,

-

Be[ore signing the deliveryreceipl,inspecl for damage and missing parts If damage or missing parts are apparenL make the appropriate notation on the delivery receipt, then sign the receipt. Immediately contact the carrier for an inspection. All material must be held in the receiving location for the carrier's inspection Deiivery receipts that have been signed without a notation of damage or

missing parts are considered to be delivered "clear" Subsequent claims are then considered to be concealed damage claims SeUle

damage claims directly with the transportation company

Lf you discover damage after receiving the unit (concealed damage), the carrier must be notified within 15 days of receipt and an inspection must be requested by telephone with confirmation in writing On concealed damage claims, the burden of establishing that the unit was damaged in transit reverts back to the claimant

Read lhe unit specification labei to verify it is the mode! ordered.

and read the meier nameplate to verify il is compatibJe with your e_ectrical conditions Make sure electrical enclosures and

componenls are appropriate for your applicafion

© IngersolL-Rand Company

Form SCD-B77A

Printed in U S A

March 2002

Image 1
Contents These INSTRUCTIONS. Retain for Reference General Safety PrecautionsDefinitions Selectinga Location Installing Discharge PipingPermanent Mounting Typical Permanent Mounting Customer.Supplied HardwareFilling Procedures Filling ProceduresService Valve Compressor LubricationNormal START-UP Filter Replacement SS3Are Finished Is free fromTank Inspection T0.9Cause Possible Solution ProblemGlm Possible Solution Limitation of Liability Warranty800AIR Serv Ingersoll-Rand Company Beery Street Box Davidson, NCWwwatr ingersoU-rand 1corn REF no QTY Connecting RODDescription Description CantREF no ConnectorWasher Spring Lock BeltguardINGERSOLL-RAND Synthetic Compressor Lubricant START-UP KITStep Saver Kits Crankcase Heater KIT