2
Removal of strips from Tool
It should be noted that fasteners with large
heads might not directly latch into the screw guide easily. If this happens, push the feed lever over with your finger while inserting the strip of screws to latch the first screw before using.
1)Move the feed lever over slightly, and then press on the end of the feed latch as in photo 3.
2)Move the feed lever back so it no longer centers the fastener as in Photo 4 and release the feed latch. This frees the screw from the feed latch.
3)Then, pull the strip towards you and then out of the tool as shown in Photo 5. This action will push over the strip tensioner spring to allow the strip to be removed easily.
3
1
Ver: 10/14/2004 | 4 |