When the bit and clip are assembled into the CH7260, it may then be attached to the driver tool. Rotate the attachment to allow the small hex end of the bit to mate with the driver. Once mated, push the attachment fully onto the aluminum adaptor. Latch the hasp.
. (Tip: if more latching force is required after a period of use, the wire part of the hasp can be bent with pliers to
For Wood applications set the screw gun torque to Max and set the starting depth control on the attachment to the middle of the adjust range and adjust attachment depth adjustment to suit.
Hex screws are normally seated using the torque control of the screw gun to prevent “stripping out” or fastener breakage. Set starting torque per chart and adjust torque until it seats consistently. The depth control on the attachment is set to “deep” to allow this per middle photo.
Ver: 10/14/2004 | 9 |