Product Specifications, Operation

PRODUCT SPECIFICATIONS

DRYWALL SCREWDRIVER		DSG50
Bit Shank Size	1/4 in. (6.4 mm) hex
Rating	120 V, 60 Hz, AC only
Input		5.4 Amperes
Switch		Variable Speed
No Load Speed		0-4,000 RPM
Overall Length		10.5 in. (267 mm)
Net Weight		3.5 lbs. (1.6 kg.)

APPLICATIONS

(Use only for the purpose listed below)

■Driving screws in drywall.

■Driving screws in wood.

SCREW CAPACITIES:

This screwdriver has been designed for driving all com- mercially available drywall screws.

OPERATION

WARNING:

Do not allow familiarity with your screwdriver to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.

SWITCH

See Figure 2.

To turn your screwdriver ON, depress the switch trigger. Release switch trigger to turn your screwdriver OFF.

LOCK-ON BUTTON

See Figure 2.

Your screwdriver is equipped with a lock-on feature which is convenient when continuous driving of screws for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your screwdriver will continue running.

To release the lock, depress the switch trigger and release.

If you have the lock-on feature engaged during use and your screwdriver becomes disconnected from power supply, disengage the lock-on feature immediately.

VARIABLE SPEED

See Figure 2.

Your screwdriver has a variable speed switch designed to allow operator control of speed and torque limits. The speed and torque of your screwdriver can be increased by depressing the switch trigger.

Note: Depress switch trigger all the way for maximum speed and torque of your screwdriver. Depress switch trigger only part of the way for less speed and torque.

Avoid running your screwdriver at low speeds for extended periods of time. Running at low speeds under constant usage may cause your screwdriver to become overheated. If this occurs, cool your screwdriver by running it without a load and at full speed.

FORWARD/REVERSE

LEVER

LOCK-ON

BUTTON

SWITCH	TO INCREASE SPEED,
TRIGGER
	DEPRESS SWITCH TRIGGER	Fig. 2

MOLDED

CORD CLIP

10 FT. (3 m)

CORD

Fig. 3

POWER CORD

See Figure 3.

Your new screwdriver has a 10 ft. (3 m) power cord that stays soft and flexible in cold weather. The plug design is shaped so that it won’t snag on your work during use. A molded cord clip on the plug makes cord storage easier.