0 When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not acceqt a full charge. This is a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.
0 If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
Removing or installing bit
CAUTION :
Always be sure that the tool i s switched off and the battery cartridge is removed before removing or installing the bit.
To remove the bit, first pull the stopper | Lock rina | |
out of the locator. | ||
| ||
Stopper |
| |
Locator | \ | |
Screw | ||
Then grasp the bit with a pair of pliers and |
| |
pull the bit out of the magnetic bit holder. |
| |
Sometimes, it helps to wiggle the bit with |
| |
the pliers as you pull. |
| |
To install the bit, push the bit firmly |
| |
into the magnetic bit holder. Then install |
| |
the stopper by pushing it firmly into the |
|
locator. | Bit holder |
|
|
| |
Depth adjustment |
|
|
Loosen the screw and adjust the locator by I | 1.5 mm - 2 mm | \ |
(1116’‘ ~5 / 6 4 ” ) | ||
|
| Lock ring |
turning it to create a distance of approxi- |
|
|
mately 1.5 - 2 mm (1/16” - 5/64”) from |
|
|
the end of the stopper to the tip of the |
|
|
bit. Tighten the screw to lock the locator. |
|
|
Then, drive a trial screw into your material |
|
|
or into a piece of duplicate material. Ob- |
|
|
serve the depth of screw penetration into | Locator |
|
the material. I f the depth is not suitable for |
| |
the screw, continue adjusting until the |
|
|
proper depth setting is obtained. |
|
|
NOTE :
The locator will be locked by tightening the screw slightly. Do not tighten it excessively, or it may be damaged.
7