Driving operation (Fig. 14)
Switch on the tool by pressing the trigger and a t the same time pushing the lock button. Hold the tool squarely against the workpiece and apply forward pressure to the tool. The screw will be automatically carried to the driving position and driven into the workpiece.
Fig. 14
IMP0RTANT :
Do not fire the tool without screws. This will damage the workpiece.
0 If the feeder box becomes sluggish in operation, spray car wax (spray type wax) on i t s sliding surfaces. Never lubricate it.
Installing or removingthe bit (Fig. 15 & 16)
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing the bit.
Loosen the bolt which secures the casing. Pull out the casing in the direction of the arrow. Press the dust cover toward the plane bearing and pull out the bit. If the dust cover cannot be moved as far as the plane bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it slightly. After installing, always make sure that the bit is securely held in place by trying to pull it out.
Plane bearing ,-
Fig. l! | Fig. 16 |
10