Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-5. Motor Section
DISASSEMBLING
1)Remove Housing R (Fig. 4)
2)Disassemble Armature from the machine as illustrated in Figs. 12 and 13.
Fig. 12
P 5/ 7
Fig. 13
|
| Carbon |
|
| brush |
|
| Torsion |
2 | 1 | spring |
|
| Carbon |
|
| brush |
1. Move the tail of Torsion spring onto the notch of Brush holder.
2. Then pull off Receptacle from Brush holder, then remove Carbon brush.
ASSEMBLING
1)Insert Armature into Yoke unit as described in Figs. 14 and 15.
2)Assemble Brush holder complete to the commutator end of Armature. (Fig. 12)
Fig. 14 | Fig. 15 |
Brush holder complete
Armature
Yoke unit
Yoke unit is not reversible when assembled to Armature.
Be sure to assemble so that the notch in Yoke unit is positioned on the
If assembled wrong, the Motor section cannot be assembled to Housing L.
[Correct] [Wrong]
Gear
notch
Because Yoke unit is a strong magnet, when assembling Armature to Yoke unit, be sure to hold the commutator portion as illustrated to left. Do not hold the Armature core as illustrated to right
or your fingers will be pinched between Yoke unit and the fan of Armature that is pulled strongly by the magnet force.