P 6/ 7
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-5. Motor Section (cont.)
ASSEMBLING
3)Assemble the Motor section to Housing L as illustrated in Fig. 16.
Fig. 16
Housing L
groove
rib
projection
notch in Yoke unit | Brush holder complete |
Assembling Yoke Unit to Housing | L |
With the projection on Housing L fitting in the notch on Yoke unit, put Yoke unit inside the four ribs on Housing L.
Assembling Brush Holder to Housing L
1)Fit Brush holder complete in the groove of Housing L.
2)The flat portion of Brush holder complete must be at 90 degrees to the edge surface of Housing L.
flat portion of Brush holder complete
edge surface of |
|
|
90 degrees |
| |
Housing L |
| |
|
|
Housing L
Brush holder complete viewed from Front cover side
[3] -6. Switch
ASSEMBLING
Put the projection on Switch between the prongs of F/R change lever, then assemble the Switch to Housing L. (Fig. 17)
Fig. 17
F/R change lever
prong
Switchprojection