Installing or removing driver bit
CAUTION:
When installing or removing the bit, be careful not to touch the trigger switch.
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise.
Be sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key coun- terclockwise in just one hole, then loosenthe chuck by hand.
1 Chuck key
Switch action
Tool speed is increased by increasing pres- sure on the trigger. To start the tool, simply pull the trigger. Releasethe trigger to stop.
7