Charging
Uncap the charging connector hole. Connect the charging plug to the charging
connector, then plug in the charger to the power receptacle. Charging takes 3 hours.
CAUTION:
0The battery in your new tool is not fully charged. You will need to charge it before use.
0Do not operate the tool during charging.
0Overcharging more than 2 days considerably shortens the battery service life. Always unplug the charger after completing the charge. Then cap the charging connector hole.
0When you charge a new tool or a tool which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the tool fully after discharging it almost completely a couple of times.
Selecting correct Phillips bit
Use the chart to determine the best size driver bit for the size of screw that you wish to use.
| Nominal Diameter (mm) |
Bit No. | Wood Screw |
| |
No. 2 |
Selecting slotted bit
Use a slotted bit that properly fits the screw slot. Use of a bit that is too small will damage the screw and/or bit.
6
