Charging
Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. Charging takes 3 hours.
CAUTION :
0The battery in your new tool is not fully charged. You will need to charge it before use. 0 Do not operate the tool during charging.
0 Overcharging more than 2 days considerably shortens the battery service life. Always unplug the charger after completing the charge.
When you charge a new tool or a tool which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the tool fully after discharging it almost completely a couple of times.
Installing bit
To install the bit, insert it into the tool as far as it will go.
Switch action | I | |
To start the tool, move the slide switch | Slide switch | |
forward. Release it to stop. | ||
|
6