Cub Cadet CC2000 manual Maintenance, Winding the Existing Inner Reel, Loop

Maintenance (continued)

Outer Spool Shaft

Inner Reel

Spring

Fig. 6-2

Indexing Teeth

Fig. 6-3

Slotted Holes

	For Use with	For Use with
	Single Line ONLY	Membrane or
		Single Line
Fig. 6-4

There are two methods to replace the trimming line.

•Wind the inner reel with new line

•Install a prewound inner reel

Winding the Existing Inner Reel

1.Hold the outer spool with one hand and unscrew the bump knob counterclockwise (Fig. 6-1). Inspect the bolt inside the bump knob to make sure it moves freely. Replace the bump knob if damaged.

2.Remove the inner reel from the outer spool (Fig. 6-2).

3.Remove spring from the inner reel (Fig. 6-2).

4.Use a clean cloth to clean the the inner reel, spring, shaft, and inner surface of the outer spool.

5.Check the indexing teeth on the inner reel and outer spool for wear (Fig. 6-3). If necessary, remove burrs or replace the reel and spool.

NOTE: Membrane line can only be used with the inner reel with the slotted holes. Single line can be used on either type of inner reel. Use Figure 6-4 to identify the inner reel you have.

NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.

Single Line Installation

Go To Step 8 for Membrane Line Installation

6.Take approximately 20 feet (6.1 m) of new trimming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel (Fig. 6-5). Pull the line through the inner reel so that the loop is as small as possible.

Fig. 6-5 Loop

13