Cub Cadet CC2000 Decorative Trimming, Maintenance Schedule, When Maintenance Needed GO to

Operation (continued)

Fig. 5-6

DECORATIVE TRIMMING

Decorative trimming is accomplished by removing all vegetation around trees, posts, fences, etc.

Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 5-6).

Section 6

Maintenance

NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to an authorized service dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as part of any seasonal tune-up.

To prevent serious injury, never do maintenance or repairs with unit running. Always do maintenance and repairs on a cool unit. Disconnect spark plug wire to ensure the unit will not start.

WHEN	MAINTENANCE NEEDED	GO TO:
Before Starting Engine	Fill fuel tank with correct oil and fuel mixture.	Page 9
Every 10 Hours	Clean and re-oil air filter.	Page 15
Every 25 Hours	Check spark arrestor and clean	Page 15
	Check spark plug condition and gap	Page 17

Bump Knob

Bolt

Fig. 6-1

LINE INSTALLATION

This section covers both Membrane line and standard single line installation.

Always use manufacturer’s 0.095 inch (2.41 mm) replacement line. Using line other than specified may make the engine overheat or fail.

Never use metal-reinforced line, wire, chain, or rope, etc. These can break off and become dangerous projectiles.

12