Makita 6705D Assembly, Overload protector, Adjusting the fastening torque, Example

Page 11

 

001760

1

2

 

3

4

1.Red mark

2.Screw

3.Number

4.Adjusting ring

ASSEMBLY

Overload protector

The overload protector automatically cuts out to break the circuit whenever heavy work is prolonged. Wait 20 - 30 sec- onds before resuming operation.

Adjusting the fastening torque

The fastening torque can be adjusted infinitely from approx. 5 kg·cm (0.4 ft·lbs) to 37 kg·cm (2.7 ft·lbs). To adjust it, loosen the two screws and turn the adjusting ring. Then tighten the screws to secure the adjusting ring.

Refer to the table for relation between the numbers on the adjusting ring and the fastening torque to be obtained.

 

 

001763

Numbers on

Fastening torque to

 

adjusting ring

be obtained

 

1

5 kg·cm (0.4 ft·lbs)

 

2

10 kg·cm (0.8 ft·lbs)

 

3

18 kg·cm (1.3 ft·lbs)

 

4

27 kg·cm (1.9 ft·lbs)

 

5

37 kg·cm (2.7 ft·lbs)

 

Example:

10kg·cm (0.8 ft·lbs) of fastening torque can be obtained when the number 2 is aligned to the red mark.

NOTE:

Always tighten the two screws to secure the adjusting ring after adjusting the fastening torque.

CAUTION:

Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.

11

Image 11
Contents Cordless Screwdriver General Safety Rules SpecificationsTool Use and Care Electrical SafetyPersonal Safety Service Specific Safety Rules100 150 SymbolsAdditional Safety Rules for Charger Battery Cartridge For DC9710 Installing or removing battery cartridgeFunctional Description ChargingFor DC1413 Tips for maintaining maximum battery life Trickle charge Maintenance chargeReversing switch action Switch actionExample AssemblyAdjusting the fastening torque Overload protectorOperation Installing or removing bitRecycling the Battery MaintenanceAccessories Memo Memo Memo Makita U.S.A., Inc Mail this Portion Factory Service Centers Makita Limited ONE Year Warranty