001761 |
12mm(15/32") |
9mm(3/8") |
001762 |
1 |
2
1.Bit
2.Sleeve
Installing or removing bit
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.
Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly.
NOTE:
•If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try
OPERATION
The proper fastening torque may differ depending upon the kind or size of screws, the type of materials to be fastened, the condition of the threads, etc. Before starting your job, always perform a test operation to verify adequate fastening torque.
Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on. As soon as the screw becomes tight, the clutch will cut in and the motor will stop automatically. Release the switch trigger.
NOTE:
•Hold the tool pointed straight at the screw, or the screw and/or bit may be damaged.
•If the motor will not start even after you pull the trigger, release the trigger. Then pull the trigger again after turning the bit slightly with your fingers.
12