Removing or installingbit
CAUTION :
Always be sure that the tool is switched off and the bit.
To remove the bit, first pull the front cap off and then pull the bit firmly. To install the bit, insert it into the tool as far as it will go and then replace the front cap.
Depth adjustment
When you wish to drive self drilling screws, etc., adjust the depth as follows. Turn the locator to adjust the depth.
I
Initially, adjust the locator to create a dis- tance of approximately 1 mm (3/64”)from the tip of the front cap (which works in conjunction with the locator) to the base of the screw head. One full turn of the locator equals 1 mm (3/64“) change in depth. After adjusting the locator, turn the adjusting ring so that the 6” mark is aligned with the pointer on the gear hous- ing. Drive a trial screw into your material
or a piece of duplicate material. If the depth i s not suitable for the screw, con-
tinue adjusting until the proper depth set- ting is obtained.
unplugged before removing or installing
Adjusting ngir- | \\ |
1 mm (3/64”)
1 mm (3/64”)
5