MODEL H6191 |
INDUSTRIAL AIR |
SCREWDRIVER |
INSTRUCTION SHEET |
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service!
DO NOT exceed 90 PSI air pressure! Personal injury or damage to tool could occur.
Introduction
This Industrial Air Screwdriver features 8,500 RPM free speed, forward and reverse directions,
Figure 1. Model H6191.
This Industrial Air Screwdriver MUST have 3-4 drops of oil directly dropped into the air fitting before each use as shown in Figure 2.
Inventory |
| |
A. | Industrial Air Screwdriver | 1 |
B. | 1⁄4" NPT Air Fitting | 1 |
C. | Phillips Head Driver | 1 |
D. | Hanger | 1 |
Operation
Screw the 1⁄4" NPT Air Fitting on the air inlet of the screwdriver. Push the Phillips head driver into the socket to lock in place. Twist the adjustment dial to set the torque to your desired setting.
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
COPYRIGHT © JULY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8462 PRINTED IN TAIWAN