OPERATING TIPS AND
Operating Guides and Tips
Avoid overloading the saw. Always use sharp blades. Do not apply exces- sive pressure to the saw while using. If the speed drops abnormally, decrease pressure immediately. If the blade stops abruptly or becomes locked, release the trigger at once. Extract the blade and determine what occured to cause this and rectifiy.
Ensure the safety of the workplace. Ensure the saw blade will not pass through bench or saw horse that workpiece may be on. Securely fix smaller objects to be cut in a vise or otherwise clamp to avoid injury. Do not attempt to hold workpiece by hand.
Avoid blade pinch. Saw blades may become pinched while cutting a work- piece that is improperly supported, very thick workpieces or when sev- eral workpieces are loosely stacked. Know how to avoid these situations to minimize risk of damage to the saw, saw blade or personal injury.
Inspect the saw before use. Run the saw before using to ensure all parts are running smoothly and there are no abnormal sounds or sparks. If any defect is found, have unit serviced.
Know your worksite. Only cut as deep as necessary. Be extremely careful when cutting behind walls for wires, other electrical hazards, gas lines, or plumbing.
Use accessories properly. Use the right blade for the job. Be aware of blade TPI necessary for the type and thick- ness of the material. Use the appro- priate blade speed- when in doubt slow the blade speed.
Maintenance
Your H0799 Reciprocating saw will give you hundreds of hours of operation time before ever needing service. The elec- trical components of this saw are not user serviceable. Repair should always be undertaken by a qualified electrical repair technician.
Keep the saw free from dirt and grease. Before cleaning or carrying out mainte- nance operations, always disconnect the tool. Never use water or other liquids to clean electrical components of the tool. Remember that regular maintenance will prevent unnecessary problems.
Keep the bottom plate clean to avoid inac- curate cuts.
Keep the exterior of the tool clean to make sure all moving parts move accurately and without wear.
Keep the ventilating slots of the motor clean to prevent the motor from overheat- ing.
Disassembly and improper reassem- bly of this device can result in elec- trical shock danger. Always have this device serviced by an qualified electrical repair technician. Serious injury will result.
H0799 Reciprocating Saw |