JBL GTS100 owner manual Fuse - 20 Amp ATC type Fuse

LINE		INPUT MODE		SPEAKER	CROSSOVER
IN	OUT	R	L+R	INPUTS	OFF	HIGH

NOM		+	+
L	STEREO	R	L	LOW
MIN		-	-
	MAX
GAIN
R
➀ Line Level RCA Inputs
➁ Line Selector
➂ Gain Control
➃ Input Mode
➄ Speaker Input Connector
➅ Crossover Mode Selector

SPEAKER
OUTPUTS		FUSE 20A
+	+	20A
R	L	BAT(+) REM GND
-	-

BRIDGED

POWER

➆Fuse

➇Battery Ground

➈ Remote Turn-On	Power
	Connector
➉ Battery (+) In

➉11 Speaker Output Connector

POWER

Power Indicator

6.Crossover Mode Selector – This switch controls the built in crossover. Set the switch to “Off” for full band operation. Set this switch to “Low” to activate the 80Hz low pass filter on the amplifier (for subwoofer use). Set the switch to “High” to activate the 100Hz high pass filter for use with satellite speakers. Note that the filter does not affect the line level outputs on the amplifier.

7.Fuse – 20 Amp ATC type Fuse.

8., 9., 10. Power Connector – Connection for included power wire har- ness. See “Power Supply Connections”

on page 14 and the wiring diagram on page 13 for information on wire color codes and proper connections.

11.Speaker Output Connector – Connection for included speaker output harness. See “Speaker Connections” section on page 17 for information on wire color codes.

12.Power Indicator LED – Power indi- cator light glows for normal operation when the amplifier is activated by either the remote or common sense turn-on circuits.

11