Specifications, Metal Pins for Rem. In AMP #

Specifications

Continuous Power Output	35 watts x 2
(20Hz – 20kHz,	(4 Ohms, 0.05% THD)
14.4V Battery Voltage)	50 watts x 2
	(2 Ohms, 0.08% THD)
	100 Watts x 1
	(4 Ohms, 0.08% THD)
Signal to Noise Ratio	100dBA
Frequency Response	10Hz – 50kHz (+0, – 1dB)
	20Hz – 20kHz (+0, – 0.1dB)
Damping Factor	>200
Slew Factor	>5
Line Level Input Sensitivity	100mV – 4V RMS (500mV at center detent)
(for rated power)
Line Level Input Impedance	10k Ohms
Speaker Level Input Impedance	15 Ohms
Speaker Level Input Sensitivity	200mV – 8V RMS (1V at center detent)
Preamp Output Sensitivity	2V Out for 4V Speaker Level Input
Minimum Speaker Impedance
Single Ended, Non-Bridged	2 Ohms
Bridged	4 Ohms
Built-In Electronic Crossover	80Hz, 18dB per octave Low Pass Filter
Frequency and Slope	100Hz, 18dB per octave High Pass Filter
Power Requirement	11 to 16V DC Negative Ground
Fuse Size	20 Amp ATC Type Fuse
Size (L x W x H)	65/8" x 91/4" x 2"
	(168.3mm x 235.0mm x 50.8mm)
Weight	4lbs. 3oz. (1.90kg)
Speaker Input / Output Mating	Molex Mini-Fit Jr. # 39-01-2040
Connector	Metal Pins: 39-00-0038
Power Mating Connector	Plastic Housing: AMP #1-480700-0
	Metal Pins for Ground & +12V: AMP # 350923-3
	Metal Pins for Rem. In: AMP # 350536-1