www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
Before carrying out any work on the saw, e.g. setting the guide plate etc., always remove the battery pack .
Never remove sawdust or splinters whilst the saw is running – always switch off the saw and remove the battery pack first.
When you are using the circular saw always wear ear protectors and protective glasses. Protective gloves, robust
Every time before using the circular saw make sure that you check it for any damage. If any parts are damaged have them fixed or replaced at a specialist repair centre.
Have a suitable tested vacuum device attached to the saw when working for long periods on woods or plastics that create dusts that are hazardous to health.
For working with wood in a closed space (interiors) a suitable dust collection device or a suitable dust protection must be used. (safety tested)
Be sure to use the integrated protection devices of the manual saw, e.g. the blade protectors . Before every use, check that the saw blade cover moves freely.
Do not allow persons under 16 years of age to use the circular saw.
Move the blade cover using the lever only. As the saw is placed on to the material to be cut, the blade cover moves back automatically. The blade cover is not to be fixed in the open position. In addition you should ensure that all moving parts of the saw blade cover function properly and all the assemblies and components involved in covering the saw blade are in perfect working order. Look out for recoil of saw or work piece when carrying out dip cuts.
Secure round timber against turning.
Do not cut materials containing asbestos.
Ensure that the parameters of the saw blade, e.g. the diameter, thickness and other technical details are suitable for the workpiece.
Ensure that the saw blade is suitable for the saw speed.
Cracked or distorted blades are not to be used. HSS (High Speed Steel) saw blades are not to be used.
When you are sawing always make sure that you do not cut through any nails, screws or the like. Set the distance between the riving knife and the tips of the saw blade teeth to a max. 5 mm, and set the distance between the tip of the riving knife and the lowest point of the saw blade to max. 5 mm.
The riving knife is only to be removed for plunge cutting.
When you switch off the saw do not use additional braking methods or press against the saw blade side to bring it to a standstill.
Note: Do not touch the saw blade teeth – danger of cutting injury.
POWERFUL - THE FAST CHARGER
Important safety advice for the charger and the battery pack
If you come into contact with alkali from the battery pack, wash off the alkali thoroughly with water. If alkali gets into your eyes, flush them out with water and seek immediate medical attention.
01.Read and take note of the operating instructions and this safety advice for the charger and the battery pack before use.
02.Warning: Use only the charger and battery pack supplied by the manufacturer. Use of any other can be hazardous.
03.Protect the charger, battery pack and electrical equipment from moisture, e.g. rain or snow.
04.Always check before using the charging device that the mains has been connected properly.
05.The charging device must be switched off immediately if you discover any damage to the mains. Make sure that the damaged mains connection is replaced immediately.
06.When you are not using the charger, remove the plug from the mains socket. Do not pull the plug with the mains connection.
5