OPERATING THE ON / OFF SWITCH
PLUNGE CUTTING
•Depress the
•Press the trigger in to turn the Jigsaw “ON” and release the trigger to stop the Jigsaw.
BUTTON
TRIGGER
SWITCH
Never feed the blade into the work piece until the blade is at full speed. If the blade is not at full speed, the saw may kick back causing serious personal injury.
•Mark out the line to be cut so it is easily visible.
•Start inside the area to be cut out.
•Depress the
•Set the shoe against the work piece.
•When the blade reaches full speed, slowly feed the blade into the work piece.
METAL CUTTING
GENERAL CUTTING
Always hold the saw in front of you and away from your body. Keep your hands and feet well away from the work piece.
Never feed the blade into the work piece until the blade is at full speed. If the blade is not at full speed, the saw may kick back causing serious personal injury.
Do not force the saw. Excessive force may result in a
broken blade. Use only enough pressure to keep the saw moving through the work piece.
•Put on eye protection.
•Clear the saw of any foreign material.
•Make sure the work piece is held securely in place. Hold smaller pieces in a vise or attach to the workbench with clamps.
•Mark out the line to be cut so it is easily visible.
•Pull the trigger to start the saw.
•Set the shoe against the work piece.
•When the blade reaches full speed, slowly feed the blade into the work piece.
Never use gasoline or any flammable liquid as a lubricant. Sparking from the motor may cause it to ignite into flames.
•When cutting metals other then copper, brass or aluminum, always use a lubricant, such as cutting oil, to keep the blade cool. This will prolong the life of the blade as well as speeding up the cutting process.
•Make sure the work piece is held securely in place. Hold smaller pieces, such as pipe or conduit, in a vise or attach to the workbench with clamps.
•To eliminate vibration, always cut close to the clamping point.
•When cutting thin sheets of metal, place a piece of plywood on either side to control vibration and prevent tearing.
MAINTENANCE AND CLEANING
Always remove the battery pack before attempting cleaning or maintenance.
This Cordless Jigsaw is lubricated before it leaves the factory. This lubrication should last for the life of the tool. No further lubrication is required.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the casing. Never immerse any part of the tool in a liquid. Always keep the ventilation openings clear.
15 | 16 |