8.Once the cutting procedure is completed, release pressure on the Trigger (37) to stop the Reciprocating Saw. If the Trigger Lock was used, squeeze and release the Trigger once to stop the Saw. Then, unplug the Saw from its electrical outlet.
(See Figure B.)
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Make sure the Trigger of the Reciprocating Saw is in its “OFF” position and that the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
2.BEFORE EACH USE, inspect the general condition of the Reciprocating Saw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, cracked or broken Saw Blades, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.TO CLEAN, use a clean cloth or vacuum to remove all dust and debris from the Reciprocating Saw. Do not use any solvents.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANU- FACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSEDTECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 4095 | For technical questions, please call | PAGE 12 |