Installing or removing wheel point
CAUTION :
Always be sure that the tool is switched off and installing or removing the wheel point.
Remove the guide from the tool when it is installed on the tool. Loosen the wing bolt and pull the guide off the front end of the tool.
Press the shaft lock to lock the spindle in place. Loosen the collet nut and insert the wheel point into the collet nut.
Use the gauge (the gauge has a hex hole which can be used as a wrench) to tighten the collet nut securely.
The wheel point should not be mounted more than 10 mm (3/8")from the collet nut. Exceeding this distance could cause vibration or a broken shaft.
the battery cartridge is removed before
Shaft lock
To remove the wheel point, follow the installation procedures in reverse.
7