Switch action

CAUTION :

Before inserting the battery cartridge into the tool, always check to see that the switch lever actuates properly and returns to the “OFF” position when released.

Operation

Switch on the tool and wait until the wheel point attains full speed. Then apply the wheel point to the blade gently. To sharpen the blade, move the tool while maintain- ing the angle of the wheel point in relation to the blade.

CAUTION :

Apply light pressure on the tool. Excessive pressure on the tool will only cause a poor finish and actuation of the overload protector.

Overload protector

The overload protector automatically cuts out to break the circuit whenever heavy work is prolonged. When this occurs, release the switch lever and withdraw the tool from the blade. Wait until the motor cools down and then resume operation.