LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use. This can be done by grasping the switch toggle (B) and pulling it out of the switch, as shown in Fig. 20. With the switch toggle (B) removed, the switch will not operate. However, should the switch toggle be removed while the sander is running, it can be turned “OFF” once, but cannot be restarted without inserting the switch toggle (B).
TRACKING THE
SANDING BELT
1.Turn the switch “ON” and “OFF” and check to see if the sanding belt tends to move to one side or the other on the two sanding drums. If the belt does not move to one side or the other and rides on the center of the sanding drums the belt is tracking properly.
2.If the sanding belt moves toward the disc, turn the tracking knob (A) Fig. 21, counterclockwise 1/4 turn.
3.If the sanding belt moves away from the disc, turn the tracking knob (A) Fig. 21, clockwise 1/4 turn.
4.Turn the switch “ON” and “OFF” again, and check to see if the sanding belt moves to one side or the other and readjust tracking knob if necessary.
CHANGING POSITION OF SANDING ARM
The sanding arm (A) can be used in the horizontal position, as shown in Fig. 22; vertical position, as shown in Fig. 23; or any angle in between by loosening screw
(B)with hex wrench (C) supplied, positioning the arm (A) to the desired angle, and tightening screw (B).
B
Fig. 20
A
Fig. 21
A
B
C
Fig. 22
A
B
Fig. 23
10
