ADJUSTING SANDING ARM STOP
A positive stop is provided to position the sanding arm level with the workbench when the arm is in the horizontal position.
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Place the sanding arm as far as possible in the hori- zontal position.
3.Place a level (A) on the sanding belt and check to see if the arm is level, as shown in Fig. 24.
4.If an adjustment is necessary, loosen lock nut (B) Fig. 24, and turn sanding arm stop (C) in or out until the sanding arm is level. Then tighten lock nut (B).
ADJUSTING BACKSTOP SQUARE WITH SANDING BELT
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.When making this adjustment make sure the belt tension lever (A) Fig. 25, is all the way to the left in the tensioned position, as shown.
3.Place a square (B) Fig. 26, on the sanding belt with one end of the square against the backstop, and check to see if the backstop is square with the sanding belt.
4.If an adjustment is necessary, loosen two screws (C) Fig. 26, and adjust the backstop accordingly. Tighten screws (C) after adjustment is made.
TILTING THE TABLE
1. | DISCONNECT MACHINE FROM POWER SOURCE. | ||
2. | The table can be tilted up to 45 degrees to the right | ||
by loosening the table lock knob (A) Fig. 27, tilting the | |||
table to the desired angle, and tightening table lock | |||
knob (A). | |||
3. |
|
| WARNING: AFTER TILTING, THE TABLE AS- |
|
| ||
|
| ||
SEMBLY MUST BE REPOSITIONED ON THE | |||
SUPPORT ROD (B) FIG. 27, TO PROVIDE A | |||
MAXIMUM OF 1/16 INCH DISTANCE BETWEEN THE | |||
SANDING DISC (C), AND THE EDGE (D) OF THE | |||
TABLE, TO AVOID TRAPPING THE WORK OR | |||
FINGERS BETWEEN THE DISC AND TABLE. TO | |||
A
B
C
Fig. 24
A
Fig. 25
B
C 
Fig. 26
C
D
B
A
REPOSITION THE TABLE ASSEMBLY, LOOSEN TWO |
SCREWS (E) AND/OR SCREW (F), MOVE TABLE |
ASSEMBLY ON ROD (B), AND TIGHTEN SCREWS (E) |
F
E
AND/OR (F). |
Fig. 27
11
