Delta 31-695 Assembling Lower Cover for Sanding Disc, Assembling Disc Sander Table

ASSEMBLING LOWER COVER FOR SANDING DISC

Assemble lower cover (A) Fig. 13, to belt and pulley guard (B) using three M4.2 x 13mm pan head screws (C).

NOTE: MAKE SURE SANDING DISC DOES NOT CON- TACT COVER. IF CONTACT IS MADE, THE SANDING DISC MUST BE REPOSITIONED ON THE DISC PLATE.

ASSEMBLING DISC

SANDER TABLE

1.Insert support rod (A) Fig. 14, into hole in side of sander until rod (A) extends approximately 5-1/2" out from the machine. Align flat on rod (A) with screw (B) and tighten screw with hex wrench (C) supplied to hold rod in position.

CB

A

Fig. 13

B

C

A

Fig. 14

2.Slide table assembly (D) Fig. 15, onto rod (A). Align flat on rod (A) with set screws (E) and tighten screws to hold table assembly (D) in position on support rod (A).

3.WARNING: To avoid trapping the work or fingers between sanding disc and table, the table edge (F) Fig. 15, should be positioned a maximum of 1/16" away from sanding disc (G). Loosen screws (E) and adjust table accordingly.

G

F

E

A

D

Fig. 15

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING SANDER

The switch (A) Fig. 19, is located on the sander base. To turn the sander “ON” move the switch to the up position. To turn the sander “OFF” move the switch to the down position.

A

Fig. 19

9