OPERATION
TO INSTALL BATTERY PACK
See Figure 5.
nPlace the battery pack in the saw aligning raised rib on battery pack with groove in the saw's battery port.
nMake sure the latches on each side of the battery pack snap into place and the battery pack is secured to saw before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installation of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 6.
nLocate the latches on the side of the battery pack and depress both sides to release the battery pack from the saw.
nRemove the battery pack from the saw.
BASE ASSEMBLY
See Figure 7.
The base assembly of your reciprocating saw pivots up and down in both directions. The base is adjustable, allowing the use of the blade teeth at different positions on the blade.
CHANGING POSITIONS OF THE BASE ASSEMBLY
nRemove the battery pack.
nLoosen the screws in the gear frame with the hex key.
nReposition the base assembly.
nRetighten the button head screws securely. Do not over- tighten screws or use an aid with the hex key.
nRemove the hex key and replace it in the storage area.
BATTERY PACK | RAISED RIB |
|
Fig. 5
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 6
HEX
KEY 
SCREW(S) |
|
BASE ASSEMBLY | Fig. 7 |
|
12