There are two methods you can employ to cut arrow shafts. One method is a THROUGH CUT, for quickly cutting arrow shafts. The other is a ROLL CUT, for more precise, cleaner cuts.
THROUGH CUTS
WARNING! Before cleaning, assembling or disassembling the Arrow Saw, make sure it is turned OFF and the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!
MOUNTING INSTRUCTIONS
For best results, mount the Arrow Saw to a solid, level surface to prevent excess vibration and movement during use. There are two holes in the Base for this purpose.
Figure 1
As an alternative,
FIGURE 1
1.Set the On/Off Power Switch to the “OFF” position. Disconnect the
Power Cord from the power source.
2. Loosen the two Thumb Screws holding the Blade Shield to the Arrow Saw. Figure 6
3.Remove the Thumb Screws and Cutting Blade Shield.
4.Using an Allen Wrench, loosen, but do not remove, the Socket Head Cap Screw securing the Arrow Shaft Guide to the Base. Figure 7
5.Adjust the Arrow Shaft Guide until the Cutting Blade extends about 1/16” PAST a fully cut arrow shaft. Figure 7
Blade Shield | FIGURE 6 |
Arrow Shaft | Thumb Screws |
| |
Guide |
|
| FIGURE 7 |
Mounting Holes
VACUUM ATTACHMENT INSTRUCTIONS
6.Firmly tighten the Socket Head Cap Screw to secure the Arrow Shaft Guide to the Base.
7.Replace the Blade Shield. CAUTION:
NEVER OPERATE THE ARROW SAW WITHOUT THE BLADE SHIELD SECURELY MOUNTED IN PLACE!
8.Secure the Blade Shield to the Arrow Saw with the Thumb Screws.
1/16”
PAST
afully cut
arrow
shaft
Arrow Shaft
Guide
Socket Head
Cap Screw
Cutting 
Blade
Arrow
Shaft
The Arrow Saw comes with two Dust Collector Adapters. Use the appropriate size Dust Collector Adapter for the vacuum hose you want to connect.
1.Set the
2.Unplug the Power Cord from the power source.
.
FIGURE 2
Dust | Dust | Vacuum |
Collector | Collector | Hose |
| Adaptor |
|
9.Check cutting depth to verify no movement occurred while securing the Arrow Shaft Guide or replacing the Blade Shield.
10.Verify the On/Off Power Switch is in the “OFF” position and connect the Arrow Saw to the power source. Turn the attached vacuum on.
11.Turn on the Arrow Saw and allow a few seconds for the Motor to reach full speed.
WARNING: ALWAYS stand clear of the Cutting Blade during start up.
CAUTION ROTATING SHARP BLADE! To avoid severe injury keep fingers, hands and other foreign objects clear of the saw opening Blade and Moving Parts of the Arrow Saw. Wear approved Safety Glasses and Kevlar Gloves when using the Arrow Saw.
3. If you are using the Small Dust Collector Adapter, connect the large end to the Dust Collector. Figure 2
.If you are using the Large Dust Collector Adapter, connect the small end to the Dust Collector.
4.Firmly insert the vacuum hose end into the open end of the Dust Collector Adapter.
5.Make sure all connections between the Arrow Saw, Dust Collector Adapter and vacuum hose are secure.