OPERATING INSTRUCTIONS
Note: Add gear oil before first use. Check gear oil level before every use. Recommended Oil Harbor Freight Tools SKU 66582. In case of un- availability, you can use the following: Shell Valvata J680®, Mobilgear SHC680®, Shell Tivela Oil s680®.
WARNING Always make sure the Power Cord (part #65) of the Circular Saw is un- plugged from its electrical outlet prior to assembly, adding any accessories, or making any adjustments to the tool.
To Adjust Depth Of Cut:
To adjust the depth at which the Circular Saw will cut, loosen the Lock Spanner (part #80) located at the rear of the Saw. Hold the Foot (part #83) down with one hand and raise or lower the Saw by the Handle (parts #60, #68). Then, retighten the Lock Spanner at the desired depth setting. (See Figure G.)
HANDLE (#60, #68)
LOCK SPANNER (#80)
FIGURE G |
| FOOT (#83) |
|
To Adjust Angle Of Cut:
To adjust the angle at which the Circular Saw will cut, loosen the Lock Spanner (part #85) located at the front of the Saw. With one hand hold the Handle (parts #59, #66), and with the other hand tilt the Foot (part #83) to the right or left until the desired angle of cut is indicated on the Angle Adjustment Scale (part #94). Then,
(See Figure H.)
HANDLE (#60, #68)
ANGLE ADJUSTMENT |
|
|
|
| ||
SCALE |
|
|
| LOCK SPANNER (#80) | ||
|
| |||||
(#91) |
|
|
| |||
|
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
| FOOT (#83) |
FIGURE H
REV 08l; 09j
SKU 90186 | PAGE 12 |