ASSEMBLY
Note: When saw is purchased, the battery pack is attached to the saw.
WARNING: Always remove battery pack from your saw when you are assembling parts, making adjustments, assembling or removing blades, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.
TO REMOVE / ATTACH BATTERY PACK
See Figure 5.
TO REMOVE:
■Depress latch located on front of battery pack (1) to release battery pack.
■Pull on battery pack (2) to remove from saw.
TO ATTACH:
■Align raised ribs on battery pack with grooves on bottom of saw, then attach battery pack to saw as shown in figure 5.
■Make sure the latch on battery pack snaps in place and battery pack is secured to saw before beginning operation.
DEPRESS LATCH TO
RELEASE BATTERY PACK
PULL TO
REMOVE
RAISED RIBS
1
2
| TO |
| INSTALL |
| GROOVES |
| TO |
| REMOVE |
BATTERY PACK | Fig. 5 |
TO INSTALL SAW BLADE
See Figure 6.
■Remove battery pack. See Figure 5.
WARNING: Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.
■Remove the 5 mm blade wrench provided with your saw from wrench holder. Note: Wrench holder is located in bottom portion of saw handle. See Figure 1.
■Loosen the blade clamp screw enough to permit the saw blade to be inserted between blade clamp and saw bar.
Note: It is never necessary to remove the blade clamp screw from the blade clamp when installing or removing blade.
■Align the hole in the shank of the blade and blade clamp with the pin in the saw bar, then seat both on the pin in the saw bar.
■Tighten blade clamp screw securely.
■Remove blade wrench and store it in wrench holder.
■Replace battery pack.
BLADE | BLADE CLAMP |
|
CLAMP SCREW |
|
|
| PIN | HOLE IN |
|
| SAW BLADE |
SAW BAR | BLADE | BLADE CLAMP |
|
|
CLAMP SCREW
BLADE
CLAMP HOLE
5 mm BLADE WRENCH | BLADE | Fig. 6 |
Note: There may be times when the blade clamp sticks to the saw bar and will not loosen enough to allow blades to be installed or removed. If this happens, loosen the blade clamp screw with the blade wrench, then tap lightly on the end of the blade wrench with a mallet. See Figure 7.
BLADE
CLAMP SCREW
BLADE CLAMP
SAW BAR
BLADE WRENCH (5 mm HEX KEY)
MALLET
Fig. 7
9