FASTENING THE MACHINE TO THE SUPPORTING SURFACE
Before operating your compound miter saw, mount it to a sturdy workbench or other supporting surface. Four holes are provided, two of which are shown at (A) Fig. 5.
When frequently moving the saw from place to place, mount the saw to a 3/4″ piece of plywood. The tool can then be easily moved from place to place and the plywood can be clamped to a supporting surface using “C” clamps.
A 
Fig. 5 |
REAR SUPPORT/STABILIZER & CARRYING HANDLE
Keep the rear support (A) Fig. 6 fully extended during all cutting operations. Push the rear support in only when storing the machine.
A 
Fig. 6 |
Use the rear support/stabilizer and carrying handle (A) Fig. 7 to carry the machine.
Carrying the machine by the switch handle will cause misalignment. Always lift and carry the machine by the base or by the carrying handle
(A) Fig. 7.
A
Fig. 7 |
9