Delta 28-263 Assembling Band SAW to Stand, Assembling Aligning V-BELT Adjusting Belt Tension

Page 5

ASSEMBLING BAND SAW TO STAND

1.Carefully place the band saw (A) Fig. 6, onto the band saw stand (B). NOTE: Position the band saw so the pulley (C) is over the opening (D) in the stand.

2.Align the four holes in the base of the band saw with the four mounting holes in the top of the stand and fasten the band saw to the stand with four 5/16-18 x 13/4 hex head screws, three of which are shown at (E) Fig. 6, with flat washers and flange nuts.

ASSEMBLING AND

ALIGNING V-BELT; ADJUSTING BELT TENSION

1.Using a straight edge, align motor pulley (A) Fig. 7, to the driven pulley (B). If necessary, both pulleys can be adjusted inward or outward. The motor (C) can also be adjusted on the motor mounting bars (D).

2.Assemble the V-belt (E) Fig. 7, to pulleys (A) and (B) and adjust the belt tension by raising or lowering the motor (C) on the motor mounting bars (D). If necessary, the motor mounting bars (D) can be repositioned on two vertical posts (F). NOTE: Make certain the pulleys are kept in alignment when doing this. Correct belt tension is obtained when there is approximately 1 deflection, using light finger pressure at the centerspan of the pulleys.

B

E

D C

A

F

Fig. 7

C

A

B

E

D

E

Fig. 6

ASSEMBLING BELT

AND PULLEY GUARD

Assemble belt and pulley guard (A) Fig. 8, to the top of the stand and surrounding the driven pulley with two 3/4-20 x 5/8 hex head screws, flat washers and hex nuts (B).

Fig. 8

5

Image 5
Contents Platinum Edition Band Saw Always Wear EYE Protection Safety RulesUnpacking and Cleaning Additional Safety Rules for Band SawsForeword Assembling the Band SAWAssembling Motor Pulley Assembling Motor to StandAssembling Belt Pulley Guard Assembling Aligning V-BELT Adjusting Belt TensionAssembling Band SAW to Stand Assembling Switch Power Connections Connecting Band SAW to Power SourceMotor Specifications Grounding InstructionsLocking Switch OFF Position Operating Controls and AdjustmentsExtension Cords Starting and Stopping the SAWTilting the Table Adjusting Table StopTable Insert Tracking the Blade Adjusting Blade TensionAdjusting Upper Blade Guides and Blade Support Bearing Adjusting Upper Blade Guide AssemblyChip Chute Adjusting Lower Blade Guides and Blade Support BearingCutting Curves Band SAW BladesOperating the Band SAW Band SAW High Carbon Steel Blades AccessoriesDELTA/PORTER-CABLE Guarantee Garantie DELTA/PORTER-CABLE Page PORTER-CABLE Delta Service Centers