Delta 28-263 instruction manual Assembling Switch

Fig. 9

ASSEMBLING SWITCH

1.MAKE CERTAIN THE BAND SAW IS DISCON- NECTED FROM THE POWER SOURCE.

2.CAUTION: THE START/STOP SWITCH-TO- MOTOR CORD (F) FIG. 9, IS TIED TO VERTICAL MOUNTING POST (G) OPPOSITE THE MOTOR PUL- LEY. THIS CABLE TIE (H) PREVENTS THE SWITCH- TO-MOTOR CORD (F), FROM CONTACTING THE BELT OR MOTOR PULLEY DURING OPERATION. IMPOR- TANT: DO NOT REMOVE THIS CABLE TIE UNLESS YOU ARE USING THE ACCESSORY#28-984HEIGHT

ATTACHMENT WITH THE BAND SAW.

3.Remove two outer hex nuts and lock washers (A) Fig. 10, from the two screws extending out from the back of the switch box (B).

4.Insert two screws (C) Fig. 10, located on back of switch box, into two holes (D) located in the band saw arm.

5.Fasten the switch box (B) to the band saw arm using two hex nuts and lockwashers (A) Fig. 11, which were re- moved in STEP 3.

6.Remove screw and cable clamp (E) Fig. 12, from lower arm of band saw.

7.Insert switch cord (F) Fig. 12, into clamp (E) which was removed in STEP 6, and fasten switch cord (F) to band saw as shown. IMPORTANT: CHECK AND MAKE

CERTAIN THE START/STOP SWITCH-TO-MOTOR CORD (F) FIG. 9, IS NOT CONTACTING MOTOR PULLEY OR BELT. ADJUST CORD (F) FIG. 9, IF NECESSARY, THEN TIGHTEN CABLE TIE (H).

A

C

D

B

Fig. 10

A

B

Fig. 11

F

E

Fig. 12

6