Operation, Switch Action | Genesis Advanced Technologies GJS450

English

OPERATION

Warning: Always check that the power supply corresponds to the voltage on the rating name plate.

SWITCH ACTION

Warning: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch can be locked in “ON” position for ease of operator comfort during extended use. Use caution

when locking tool in “ON” position and maintain a firm grasp on the tool.

Your jig saw is equipped with an “ON/OFF” switch trigger which is operated by squeezing or releasing.

•To start the tool, simply pull the switch trigger.

•To stop the tool, release the switch trigger.

Using with the “Lock-On” button:

Your jig saw is also equipped with a “Lock-On” button, located on the left side of the saw's handle just above the switch trigger. Using the “Lock-On” button allows the saw to be run continuously without the operator having to constantly apply pressure to the switch trigger.

•To start the tool and run the tool continuously, pull the switch trigger then push in the “Lock-On” button and release the switch trigger.

•To unlock the switch, pull the switch trigger fully and release it.

Warning: If the “Lock-On” button is continuously being depressed, the trigger cannot be released.

TO INSTALL OR REMOVE THE SAW BLADE

Warning: Always be sure that the tool is switched off and unplugged before adjusting, adding accessories, or checking a function on the tool

CAUTION: Always clean out all chips or foreign matter adhering to the blade and/or blade holder. Failure to do so may cause insufficient tightening of the blade, resulting in a serious personal injury. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Always secure the blade firmly. Insufficient tightening of the blade may cause blade breakage or serious personal injury.

To install the blade:

1.Position the chip shield up to allow access to the Blade Collet.

2.Open the Blade Collet by rotating the (Spring Loaded) Collet Lever clockwise.

3.With the blade teeth facing forward, insert the blade into the Blade Collet as far as it will go.

4.Check to make sure the back edge of the blade is positioned properly in the groove of the roller guide.

5.Release the Collet Lever. The blade should now secured in the Blade Collet.

6.Lower the chip shield completely.

FIG 2

BLADE COLLET COLLET LEVER

ROLLER GUIDE

Variable Speed Jig Saw
Operator’s Manual	GJS450