English
2.Slide base backward until base pivot screws can move freely in the grooves in base.
3.Align the mark, on the base, of the desired angle with the edge of motor housing.
4.Once desired angle is reached, slide base forward to engage stop slots to notches on housing, tighten the base pivot screws securely.
NOTE: For angles other than the preset 15° increments, the stop notches at the front of the base are not used.
INTERIOR CUTOUTS
An interior cutout is needed when a cutting pattern is located in the work piece without a
Using starting holes
Within the cutout pattern,
Using plunge cutting
Warning: To avoid loss of control, broken blades, or damage to the material being cut, always use extreme caution when making plunge cuts. We do not recommend plunge cutting on materials other than wood.
When using the plunge cutting method, a starting hole or lead in cut from the work piece edge is not necessary. It is best to practice plunge cutting on scrap wood so the operator becomes familiar with the technique.
1.Set the speed at 5 or 6 and orbital setting to III.
2.Tilt the saw forward so that it rests on the front edge of the base with the blade point positioned just above the work piece surface.
3.Make sure the blade is inside the area to be cut.
4.Apply downward pressure to the tool so that the front edge of the base will not move when you turn on the tool.
5.Turn on the tool and gently lower the back end of the saw until the blade contacts the work surface.
6.As the blade pierces the workpiece, slowly lower the base of the tool down onto the workpiece surface until it is in the normal cutting position.
7.Complete the cut in the normal manner.
SCROLL CUTTING
Scroll cuts can be made with the jig saw by guiding the direction of the cut with applied pressure on the handle.
Warning: Excessive side pressure to the blade could result in broken blades or damage to the material being cut.
Variable Speed Jig Saw |
|
Operator’s Manual | GJS450 |